Digital Thermometer/Hydrometer -
(found at Wal-Mart [Hardware dept - $11.88] -
Lowes, Home Depot, etc for less than $15)
(Dial and "Stick On" gauges are Crap)
the probe from the therm/hydrometer goes IN the Warm Side Hide -
the unit goes In the cool side, Inside the tub/tank.


You need to get something similar to this...

Temps should read:
     Warm Side: between 90f - 94f (32.22C - 34.44 C)
     Cool Side:between 80f - 84f (26.67 C - 28.89 C)
     Humidity: between 50-60% (70% when in shed)

*although some prefer to use lower temps, but personally, I would not go too much lower.

     the Probe goes Inside the Warm hide
     (dont attach it to the hide - makes for a pain when cleaning)
     again... The Unit goes on cool side... near the bottom of enclosure
     In temp = Cool side temp
     Out temp = Warm side temp
     Bottom Reading = Humidity Level


The heat provided should be obtained by using a UTH (under Tank Heater)
Controlled by a Thermostat, or a dimmer switch at the least!