#97413

 Building a new viv

i am going to build a new enclosure out of wood and mesh, so how big should i make this new enclosure? i was thinkin, 7 feet wide, by 6 feet deep, by 8 feet high.

 #97418

 Building a new viv

Man, that will be a big home. Hope you have the room and do you realize how many dragons you could house. Our is 6’2"H 3’2"L 3’2"W and that can house 7 full grown dragons.

 #97464

 Building a new viv

thank you for your fast response, so if i used your sizes than i could house 7 dragons! woah, i think that i will use your dimensions than, but a little bigger. thanx again skjonnhet.

 #98022

 Building a new viv

and what materiles should i use to bilud my new viv? i am going to use mesh for the outsides, bit i dont know what to use for the frame, top and bottom. anybody have any suggestions?

 #98129

 Building a new viv

.....anybody know what is safe to use?

 #98139

 Building a new viv

I heard, not overly sure, but it sounds kinda right, that most of the studs, i.e. 2x4’s you’re going to find are resinous. Pretty much Spruce and that’s not good for WDs. However if you were to coat it with poly it should be fine right? If not I’d say get some aspen or poplar boards and cut them into the right size for a frame.

 #98344

 Building a new viv

OK meant to say that I didn’t think spruce was good for WDs. Can’t rightly say what is and isn’t good for them without having one first, huh?

 #98569

 Building a new viv

I just built a new viv for my waterdragon...(and frog)..it’s 4 feet long, three feet wide and two feet deep....how many waterdragons could I house in there...I wanted to get two babies...male and female and attempt to breed them...also, do you think that if I put babies in with Mitchie who is a year....do you think he’ll hurt them?